DC01 | 1.0330

DC01 | 1.0330: Properties according to DIN EN 10 130

Steel type

DC01 | 1.0330: Mechanical properties (transverse)

DC01 | 1.0330: Chemical composition (heat analysis)

1) Where no yield strength is defined, the respective values shall apply to the 0.2 % proof stress (Rp0.2) or to the lower yield strength (ReL). For thicknesses ≤ 0.7 mm but > 0.5 mm, the maximum yield strength values may be 20 MPa higher. In case of thicknesses ≤ 0.5 mm, the maximum yield limits may be 40 MPa higher.

2) For thicknesses ≤ 0.7 mm but > 0.5 mm, the minimum elongation at fracture may be 2 units lower. For thicknesses ≤ 0.5 mm, the minimum elongation at fracture may be 4 units lower.

3) The r90 and n90 values apply to product thicknesses ≥ 0.5 mm only.

4) For thicknesses > 2 mm, the r90-value is reduced by 0.2.

• The grades are classified according to the maximum permissible yield strength and can be subdivided as follows.

DC01 – This grade can be used for simple forming work, for example Bending, embossing, beading and pulling are used.
DC03 – This grade is suitable for forming requirements such as Deep drawing and difficult profiles suitable.
DC04 – This quality is suitable for high deformation requirements.
DC05 – This thermoforming grade is suitable for higher forming requirements.
DC06 – This special deep drawing quality is suitable for the highest deformation requirements.
DC07 – This super deep drawing quality is suitable for extreme deformation requirements.
 

Packaging and shipping

Hot Tags: dc01 | 1.0330, China dc01 | 1.0330 manufacturers, suppliers, factory, Gi zero spangle, gi steel coil, coil galvanized, dx51d z Galvanized Steel Coil, Galvanized Carbon Steel Hot Rolled Cold Rolled Coil 1075, galvanized sheet coil