1.How corrosion-resistant is DX51D AZ250?
The aluminum in the coating forms a dense aluminum oxide film, preventing the penetration of corrosive media. The zinc provides sacrificial anodic protection. This dual protection makes it far more corrosion-resistant than ordinary galvanized sheet. In a neutral salt spray test, it can withstand 1500-2000 hours without red rust, making it suitable for use in corrosive environments such as high humidity, coastal areas, and industrial pollution.

2.How is the high temperature resistance performance of DX51D AZ250?
The long-term operating temperature can reach 300℃, and the short-term temperature resistance can reach 600℃. It can be used in scenes close to heat sources, such as oven linings, industrial chimneys, etc.

3.What is the machining performance of DX51D AZ250?
It can be subjected to cold processing such as bending, stamping, and shearing. The coating has strong adhesion and is not prone to peeling or cracking. Its minimum bending radius is ≥1.5 times the plate thickness, and the T-bend test can reach 0T level, which means that the coating will not peel off after bending 180°.

4.What is the surface quality of DX51D AZ250?
The coating has a silvery-white metallic luster, a smooth surface and high reflectivity, which can reduce the absorption of solar radiation. It is suitable for exterior use in buildings such as roofs and curtain walls, and can also reduce indoor energy consumption.
5.What are the shortcomings of DX51D AZ250?
Welding is difficult: The aluminum in the coating easily forms an oxide film at high temperatures, which affects welding conductivity and weld pool fluidity. Special welding methods and techniques are required, such as cleaning the coating near the weld point or increasing the current to break the oxide film before welding. It is also not suitable for gas welding.
Higher Cost: Compared with ordinary galvanized sheet, its production process is more complex and the raw material costs are higher, resulting in a higher initial purchase cost.
Unsuitable for deep drawing: Although it has certain processability, it is not suitable for more difficult processes such as deep drawing, which may cause localized overstretching and cracking of the coating.
Special treatment is required for incisions: The incisions after processing are not protected by the coating and are prone to rust. They require timely application of anti-rust paint or a zinc-rich cold spray zinc agent, which increases processing steps and costs.

