Are cold-rolled coils suitable for making gaskets?

Mar 11, 2026 Leave a message

1.Why are cold-rolled coils suitable for making gaskets?

High precision and good surface finish: Cold-rolled coils have a smooth and flat surface with strict thickness tolerance control. This results in dimensionally stable stamped gaskets with minimal burrs, allowing for direct use without additional machining.

Moderate and stable strength: Compared to hot-rolled sheets, cold-rolled coils have higher hardness (a certain compressive strength) and less springback during stamping, making it easier to maintain their shape.

Low cost and high efficiency: Ideal for high-speed stamping and mass production, offering high material utilization and extremely high production efficiency.

cold-rolled coil

2.What are the requirements for cold-rolled coils used in general machinery, electrical, and construction gaskets?

Suitability: Very suitable.

Recommended grade: Q235 (ordinary carbon structural steel cold-rolled sheet, such as SPCC) or 08F (high-quality carbon structural steel cold-rolled sheet).

Note: For most ordinary gaskets that do not require high strength and only need to fill gaps or prevent loosening, ordinary cold-rolled sheet is the most economical choice.

cold-rolled coil

3.What are the requirements for a gasket with a certain degree of elasticity or hardness?

Applicability: Suitable (heat treatment required).

Recommended Grades: 65Mn (cold-rolled spring steel strip) or 60Si2Mn.

Note: If you are making wave washers, saddle washers, or flat washers that require increased hardness, using ordinary cold-rolled steel sheet (Q235) is too soft and prone to deformation. In this case, you should use cold-rolled spring steel strip (such as 65Mn), which should be stamped and then quenched and tempered (heat treatment) to achieve high elasticity and hardness.

cold-rolled coil

4.Are cold-rolled coils suitable for high-precision, thin gaskets?

Suitability: Very suitable.

• Recommended grade: High-quality carbon steel cold-rolled strip.

• Note: Cold-rolled coils are available in extremely thin strips of 0.1mm, 0.2mm, and 0.3mm, with extremely tight thickness tolerances (such as PT.A or PT.B grades in GB/T 708), making them ideal for precision adjusting shims.

 

5.Can ordinary cold-rolled coils be used in special environments (high temperature, corrosion)?

Not suitable for ordinary cold-rolled coils: Ordinary cold-rolled steel is prone to rusting when exposed to water or moisture.

Alternatives:

Rust prevention/decorative: Use stainless steel cold-rolled coils (such as SUS304, SUS316) or surface treatments (galvanizing, blackening).

Insulation/vibration damping: In this case, non-metallic materials (such as red steel foil, rubber, PTFE, nylon) should be selected instead of steel cold-rolled coils.

High temperature: Heat-resistant steel or heat-resistant alloys must be selected.