Can carburizing improve the overall hardness of DC06?

Aug 25, 2025 Leave a message

Can carburizing improve the overall hardness of DC06?

Carburizing does not significantly increase the overall hardness of DC06. Its hardening effect is primarily concentrated in the surface layer, leaving the core hardness largely unchanged. This is due to the characteristics of the carburizing process and the material properties of DC06. The specific reasons are as follows:
1. Hardening Principle and Scope of Carburizing

Carburizing is a surface chemical heat treatment process that penetrates carbon atoms into the surface layer of steel at high temperatures (850-930°C), increasing the carbon content from the original DC06 carbon content of ≤0.008% to 0.8-1.2% (in the high-carbon steel range). Subsequently, quenching and low-temperature tempering form a high-hardness martensitic structure on the surface layer, achieving surface hardening.

However, carburizing has a limited penetration depth (typically 0.1-1.0 mm, depending on the treatment time and temperature). Beyond this depth, the carbon content rapidly drops to the original base material level (≤0.008%). Therefore, the hardening effect is limited to the surface layer within a few millimeters, while the core remains in its original ultra-low carbon ferrite structure, with virtually no change in hardness.
II. Hardness Distribution Characteristics of DC06 Steel After Carburizing
Taking a 1.0mm thick DC06 steel plate as an example, the hardness distribution after carburizing (0.2mm carburized layer) is as follows:
Surface layer (0-0.2mm): After quenching, the hardness reaches 55-65 HRC (approximately 530-700 HV), significantly improving wear resistance;
Transition layer (0.2-0.3mm): The carbon content decreases with increasing depth, and the hardness drops rapidly to 30-40 HRC;
Core (>0.3mm): The carbon content remains ≤0.008%, the structure is ferrite, and the hardness remains the original state (50-70 HRB, approximately 80-130 HV).
As can be seen, after carburizing DC06, only the surface hardens, while the overall hardness (especially the core) remains unchanged, resulting in a "hard surface, soft core" condition.

III. Core Reasons for Failure to Improve Overall Hardness

Limitations of the Carburizing Process:
Carbon atoms diffuse slowly in steel, and due to temperature and time constraints, they cannot penetrate deeply into the material (especially in thick plates). This process only strengthens the surface, without changing the overall composition and structure.

DC06's Ultra-Low Carbon Characteristics:
DC06 has an extremely low carbon content (≤0.008%). Even after quenching, the core cannot form martensite (martensite formation requires a carbon content of ≥0.2%), maintaining a soft ferrite structure. Therefore, carburizing cannot increase the core hardness.

IV. Applications and Alternatives

Applications of Carburizing: Parts requiring only surface wear resistance while maintaining toughness in the core (such as the surface wear layer of gears and bushings). The plasticity of the DC06 core can be used to absorb impact loads, while simultaneously improving wear resistance through surface hardening. Alternatives for Overall Hardness Improvement: If overall hardening of DC06 is desired, cold work hardening is necessary (e.g., secondary cold rolling with a 20-30% reduction can increase overall hardness to 80-95 HRB), but this will sacrifice ductility. If material substitution is possible, medium-carbon steel (e.g., 1045) or low-alloy steel (e.g., 20CrMnTi) can be used, as they offer a more pronounced overall carburizing hardening effect.

In summary, carburizing is a "localized surface strengthening method" for DC06, not an "overall hardening method." Its core value lies in balancing surface wear resistance and core toughness, not in increasing overall hardness.