1.How does substrate material affect bending performance?
High-quality substrates (such as DX53D/DX54D, CR4, etc.): These materials are specifically designed for deep drawing, bending, and other forming processes. They have high elongation and excellent plasticity, allowing them to withstand large bending deformations without breaking.
Ordinary substrates (such as DX51D, CR1, etc.): These materials are suitable for simple bending and forming. However, if the bend radius is too small or the angle is too sharp, there is a risk of cracking.

2.How does the galvanizing layer affect bending performance?
The zinc layer itself is relatively soft: It provides some lubrication and cushioning during bending.
Zinc Adhesion: High-quality galvanized coils have a very strong zinc layer bonded to the steel substrate and will not easily flake off during bending.
Bend Appearance: On the outer side of the bend (the side under tension), the zinc layer may develop fine, almost invisible "hairline" cracks. This is normal. As long as the zinc layer has good adhesion, its corrosion resistance will not be significantly affected, as the surrounding zinc will still provide "sacrificial protection."

3.What are the key points to pay attention to when bending?
Bend Radius (Most Important!)
Basic Principle: The larger the bend radius, the less likely it is to crack.
Minimum Bend Radius: Generally, the inner radius (R angle) should not be less than the sheet thickness.
For example, for a 1.0mm thick galvanized coil, a minimum bend inner radius R ≥ 1.0mm is recommended.
For more demanding applications, a larger radius, such as R ≥ 1.5t - 2t (t is thickness), is recommended to maximize the integrity of the zinc layer.
Bending Direction
Preferably, bend perpendicular to the rolling direction: Keep the bend line perpendicular to the rolling direction of the coil whenever possible.
Reason: Steel generally has greater plasticity in the rolling direction (longitudinal direction) than in the transverse direction. Bending perpendicular to the rolling direction prevents excessive deformation in the transverse direction, where plasticity is less, which can lead to cracking.

4.What problems may occur after bending?
Substrate cracking, zinc layer peeling/skinning, surface scratches
5.What are the solutions to possible problems that may arise after bending?
Substrate cracking: Increase the bending radius, replace with a higher grade galvanized coil, and adjust the bending direction
Zinc layer peeling/flaking: Choose a supplier with reliable quality, increase the bending radius, polish the mold or replace it with a new one
Surface scratches: Clean the mold and workbench

