1.What are the reasons for white rust on the surface?
Cause: In a humid, unventilated environment, the zinc coating reacts with moisture and oxygen to form a white, fluffy basic zinc carbonate or zinc oxide.
Appearance: White or gray powdery, filmy patches.
Severity: Mild oxidation. This condition only attacks the surface zinc coating, leaving the steel base undamaged. This is the easiest to repair.

2.What are the causes of dark spots/dullness on the surface?
Cause: A dense oxide film naturally formed on the zinc layer in the air, or as a result of reactions with sulfides.
Appearance: The surface is dark or black, but still smooth to the touch.
Severity: Very mild. This dense oxide film can sometimes even provide protection, but is usually applied for cosmetic reasons.

3.What are the causes of red rust on the surface?
Cause: The zinc layer has completely corroded, leaving the underlying steel substrate rusting.
Appearance: Red or brown rust.
Severity: Moderate to severe oxidation. Rust protection is lost, making repair difficult and resulting in reduced performance.

4.How to perform surface cleaning and passivation?
Chemical Cleaning:
For white rust: Use a dilute acetic acid solution (vinegar is sufficient) or a 5%-10% phosphoric acid solution. These weak acids react with the white rust to form water-soluble zinc salts.
For black spots: Use a diluted ammonia solution.
How to: Use a soft cloth or brush dipped in the solution and wipe the oxidized surface until the white or black material disappears.
Mechanical Cleaning:
For light white rust, you can use a clean rag, scouring pad (use the finer end), or a soft-bristle brush for wet or dry cleaning.
Key: Be gentle and aim to remove corrosion products, not to remove the intact zinc layer.
Post-treatment:
Flushing with clean water: After using a chemical treatment, rinse the surface thoroughly with clean water to remove all chemical residue.
Dry thoroughly: Immediately dry with a clean cloth or blow dry with compressed air to prevent secondary rusting.
Passivation: After the surface is clean and dry, spray or brush on a chromate passivation solution or a chromium-free passivation solution. This creates a new, dense protective film on the zinc layer, preventing the recurrence of white rust. This is a critical step in a successful repair.
5.How to remove rust and rebuild the zinc layer?
Surface Treatment:
Mechanical Rust Removal: Use sandpaper, a wire wheel, an angle grinder with a wire brush, or a louver to thoroughly remove the rusted area and the surrounding loose zinc layer until the metallic luster is exposed. For larger areas, sandblasting is the most effective method.
Acid Cleaning: Industrially, acid cleaning with hydrochloric acid or other acids is recommended, but the time and concentration must be strictly controlled to prevent corrosion of intact surfaces. This also carries high environmental costs and is not suitable for small-scale, on-site treatment.
Restoring the Rust-Proofing Layer:
Applying zinc-rich paint: This is the most common and effective repair method.
How it works: Zinc-rich paint contains a large amount of zinc powder. When applied to the polished area, the zinc powder in the resulting paint film, after drying, acts as a "sacrificial anode" to further protect the steel substrate.
How to Apply: Apply zinc-rich paint evenly to the cleaned metal surface. Two or more coats are usually required to ensure a thick and continuous paint film.

