1.Why is the spot weld strength of tin-plated steel sheets low?
Low-melting-point, low-resistivity interference layer:
Tin has a melting point of only 232°C, while steel has a melting point of approximately 1500°C. Initially, when current is applied, the tin layer melts instantaneously, causing drastic and unstable changes in the actual contact area and contact resistance between the two plates.
Tin's resistivity is much lower than steel's, which causes some current to be diverted by the tin layer, reducing the effective heat available for forming the steel-to-steel weld nugget.
Difficulty in weld nugget formation:
An ideal weld nugget should be a "fusion nugget" formed by the fusion of two steel base materials. However, molten tin contaminates the contact interface, hindering direct fusion between the steel and steel. Simultaneously, molten tin may be squeezed around the weld nugget, forming a "ring-like bond," appearing welded, but with a small or nonexistent core steel-to-steel fusion zone (called a "cold weld").
This incomplete or irregular weld nugget directly leads to a reduced load-bearing area and decreased strength.
Prone to spatter and defects:
Due to the unstable melting process of the tin layer, it is easy to cause instantaneous vaporization or metal spatter, leaving defects such as holes and cracks in the solder nugget, further weakening its strength.

2.When pursuing high intensity, how should one choose?
For structural components and load-bearing parts (such as vehicle body frames, chassis components, and cabinet frames), cold-rolled coils or their variants (such as high-strength steel, welded before galvanizing) must be used to ensure the reliability and safety of the welded joints.

3.In what situations is it necessary to use tin-plated plates?
Hard-specification soldering: Employs high current and short-duration soldering parameters. The aim is to quickly generate sufficient heat inside the steel plate to form a weld nugget before the tin layer completely melts and causes serious interference.
Precise control: Requires more precise welding machines and parameter monitoring.
Electrode management: Tin easily adheres to the electrode tips, leading to electrode contamination and deformation, requiring more frequent grinding and maintenance.
Expected strength: Even with optimized processes, the weld strength is typically only 60%-80% of that of cold-rolled steel of the same thickness, with significant variation. The design needs to increase the number of weld points or employ other reinforcement methods.

4.What are the differences in surface finish between cold-rolled coils and tin-plated sheets?
Cold-rolled coil: Clean, bare steel surface, possibly with a light application of anti-rust oil.
Tinplate: Surface is a tin layer (and tin-iron alloy layer), usually with a passivation film and lubricant.
5.What are the fundamental principles when making a choice?
If weld strength is the primary consideration, spot welding with tinplate should be avoided; if tinplate must be used due to requirements such as corrosion protection, its lower weld strength must be accepted and optimized through strict process control.

