DC01 Cold Rolled Steel Coil: Properties, Equivalents and Applications

May 07, 2025 Leave a message

What Is DC01?

DC01 is a cold-rolled low-carbon steel grade defined in EN 10130, the European standard for cold-rolled low-carbon steel flat products for cold forming. It is supplied as cold-rolled coil or sheet and is one of the most common grades for simple bending, drawing and general stamping. In Chinese practice it is often compared with grades 08, 08F and 08Al under GB/T 5213-2019, and with specifications such as Baosteel Q/BQB 403.

Chemical Composition and Mechanical Properties

DC01 has a maximum carbon content of 0.12%, maximum manganese of 0.60%, and maximum phosphorus and sulfur of 0.045% each, with a residual aluminum content of at least 0.020%. The guaranteed mechanical properties are a yield strength of 130-260 MPa, a tensile strength of 270-410 MPa and a minimum elongation of 28%.

Property Value
Carbon (max) 0.12%
Manganese (max) 0.60%
Phosphorus (max) 0.045%
Sulfur (max) 0.045%
Yield strength 130-260 MPa
Tensile strength 270-410 MPa
Elongation (min) 28%

Grade Equivalents

Within EN 10130, the DC family runs from DC01 to DC06 with increasing formability. Outside Europe, comparable grades include SPCC under JIS G3141 and, in China, 08, 08F and 08Al per GB/T 5213-2019; many mills also publish equivalents in their own specifications such as Q/BQB 403. Equivalence should always be confirmed by comparing the full chemical and mechanical requirements, not the grade name alone.

From DC01 to DC06: The Forming Capability Ladder

EN 10130 grades are ranked by formability: DC01 for simple bending and shallow drawing, DC03 for drawing, DC04 for deep drawing, DC05 for extra deep drawing, and DC06 for the most demanding deep-drawing operations. DC05 and DC06 are not thermal-forming grades; they are low-carbon and interstitial-free type steels whose higher r-values and elongation make them suitable for severe forming operations.

Typical Applications

DC01 is used in automotive body components that require only simple forming, household appliance casings and inner parts, office furniture, metal packaging, and a wide range of light metal products. Where surface quality matters, the appropriate surface finish per EN 10130 must be agreed between buyer and mill and recorded on the certificate.

Frequently Asked Questions

What does DC01 stand for? DC stands for cold-rolled low-carbon steel for direct cold forming; 01 is the lowest formability class in the EN 10130 DC series.

Is DC01 the same as Q235? No. Q235 is a Chinese structural steel grade to GB/T 700 with different chemistry and mechanical requirements, while DC01 is a cold-rolled forming grade to EN 10130.

Can DC01 be deep drawn? DC01 supports only light to moderate deformation. For deep drawing, use DC03, DC04 or higher grades depending on the drawing severity.

What is the difference between DC01 and DC03? DC03 has a lower carbon limit and improved formability; the two grades are designated for different levels of drawing severity.

What are 08F and 08Al? They are Chinese grade designations per GB/T 5213-2019 commonly treated as equivalents of DC01-type cold-rolled steel; verify the full specification before substitution.

How is elongation measured for DC01? Elongation is measured in a tensile test on a standard specimen, with a minimum of 28% guaranteed by EN 10130.