1.Why is neutralization/rinsing necessary?
Removing Residual Acid: After pickling, a large amount of residual acid (mainly hydrochloric acid or sulfuric acid) adheres to the surface and crevices of the strip. If not thoroughly removed, this acid will:
Continue to corrode the strip: Corrosion will continue even during subsequent coiling and storage, leading to rust on the strip surface and severely affecting product quality.
Damage subsequent equipment: Residual acid will corrode expensive equipment such as rolling mills and annealing furnaces.
Affect the performance of rolling oil/lubricant: Acid will react adversely with rolling oil, affecting rolling performance and surface cleanliness.
Preparing a clean surface for subsequent processes:
Rolling: An absolutely clean, contaminant-free metal surface is required to ensure a stable rolling process and obtain good sheet shape and surface quality.
Zinc/Tin Plating, etc.: Subsequent coating processes have extremely high requirements for the cleanliness of the substrate; any acid or salt residue will lead to poor coating adhesion and defects.
Formation of a temporary protective layer (passivation):
In modern pickling lines, the final rinse water is typically a rust-preventive solution containing trace amounts of passivating agents (such as phosphates, silicates, or certain organic reagents).
This extremely thin protective film prevents the strip from rusting again in a short period (the short time from the pickling line exit to the cold rolling mill entrance), providing qualified raw materials for the cold rolling process.

2.What is the pre-washing/squeezing process?
The strip first passes through a pair of squeeze rollers to squeeze out most of the acid it carries.

3.What is the multi-stage countercurrent rinsing process?
The steel strip first enters the last (cleanest) rinsing tank, moving forward in stages.
The flow of the cleaning water is opposite to that of the steel strip: fresh deionized water or demineralized water is added from the last rinsing tank and then overflows into the previous tank, and so on.
This "counter-current" design uses water resources most efficiently, rinsing the steel strip with the cleanest water before it enters the next process, ensuring optimal cleaning results and minimal water consumption.

4.What are the rinsing and passivation processes?
In the final rinsing tank, a prepared rust inhibitor is added to lightly passivate the surface of the strip steel.
5.What is the drying process?
After rinsing, the strip immediately enters the hot air drying device to thoroughly remove surface moisture and ensure it is completely dry before entering the rolling mill or coiling.

