Is the hardness of cold-rolled coil related to its springback rate?

Jan 27, 2026 Leave a message

1.What is the core relationship between the hardness and springback rate of cold-rolled coils?

The essence of hardness: Hardness is a material's ability to resist localized plastic deformation (such as indentation). For the same type of steel, hardness and yield strength have an approximately linear proportional relationship. Higher hardness means higher yield strength.

The essence of springback: Springback is the phenomenon where, during the forming process, after the external load (impact force) is removed, the elastically deformed portion of the material recovers. Its magnitude depends on the ratio of elastic deformation to plastic deformation.

Logic chain:

High hardness → High yield strength → Material is more difficult to plastically deform.

Under the same amount of forming deformation, materials with high yield strength require greater force to yield.

When the external force is unloaded, the material stores more elastic deformation energy, resulting in a stronger "force" to return to its original shape, thus leading to a greater amount of springback (springback rate).

cold-rolled coil

2.What are the differences between cold-rolled coils before and after annealing?

Cold-rolled state: The material is in a work-hardened state, with high hardness and high yield strength. During stamping, the material is "stubborn," with most deformation being elastic; it springs back with the slightest relaxation, leading to severe springback and making it difficult to control the size and shape of the parts.

Annealed state: Work hardening is eliminated through recrystallization, the material softens, and the yield strength decreases. During stamping, the material is "compliant," easily undergoing irreversible plastic deformation. The elastic recovery portion is small, resulting in less springback and better part shape retention.

cold-rolled coil

3.How should material selection and condition control be adjusted?

Choose soft materials: For complex formed parts, prioritize fully annealed soft cold-rolled coils (such as DC04, SPCC-SD) due to their low hardness and low springback.

Precisely control the annealing process: As you previously asked, by controlling the annealing temperature and time, the target hardness and mechanical properties can be obtained, thereby predicting and controlling springback.

cold-rolled coil

4.How can the process be compensated?

Mold Correction: Based on experience or CAE simulation, the springback amount is pre-calculated, and reverse compensation is performed on the mold surface (i.e., the mold is intentionally made into an "over-bent" or "over-twisted" shape so that the springback will return to the correct shape).

Adding Molding Processes: For example, using a two-step "molding + shaping" method, springback is corrected during the shaping stage.

Adjusting Process Parameters: Increasing the blank holder force, using draw beads, etc., changes the stress state of the material during molding, which can sometimes reduce springback.

 

5.What are the application strategies?

To reduce springback and improve forming accuracy, low-hardness (low carbon, fully annealed) cold-rolled materials should be preferred. When the material hardness is fixed, springback must be compensated for through mold design and process adjustments.