Mechanical Properties in Application
The Effect of Temperature on Mechanical Properties
The strength of Q345 decreases with increasing temperature, while its toughness decreases with decreasing temperature:
When temperatures exceed 300°C, the yield strength decreases significantly (for example, at 350°C, it is approximately 70% of room temperature). Avoid use in high-temperature, long-term load-bearing applications.
When temperatures are below the impact temperature of the corresponding quality grade (for example, below -20°C for Q345B), "low-temperature brittle fracture" may occur. Therefore, the quality grade and ambient operating temperature must be strictly matched.
The Effect of Welding on Mechanical Properties
During welding, grain coarsening in the heat-affected zone (HAZ) may occur, leading to a localized decrease in toughness (especially when preheating is not performed or cooling is too rapid). The following measures should be taken to avoid this:
Select matching low-hydrogen electrodes (such as E5015) or wires (such as ER50-6);
Preheat before welding (for thickness > 20mm, preheat temperature ≥ 80°C). Slow cooling or stress relief heat treatment should be performed after welding. Design Considerations for Thickness Effects
The yield strength of thick plates (>63mm) is reduced. Therefore, design calculations must be based on the actual thickness to avoid safety hazards caused by designing for thin materials.
In summary, the mechanical properties of Q345 steel are centered around a yield strength of 345 MPa. A balance of strength, ductility, and toughness is achieved through alloying and process control. Performance varies across different quality grades and delivery states, and selection must be tailored to the specific application scenario (temperature, load, and processing method) to ensure structural safety and reliability.
Mechanical Properties in Application
Sep 01, 2025
Leave a message

