Is the peeling of the coating on pre-painted steel coils related to temperature fluctuations?

Dec 18, 2025 Leave a message

1.What are the curing issues during the production process?

Insufficient curing (too low a temperature or too short a time): The resin inside the coating does not undergo complete cross-linking, resulting in:

Poor adhesion, like an "underbaked cookie," easily peeling off the substrate.

A soft coating with poor hardness, weather resistance, and chemical resistance, making it more susceptible to damage.

Over-baking (too high a temperature or too long a time): The coating resin undergoes excessive cross-linking, becoming brittle. Although adhesion may be acceptable in the short term, the coating loses its elasticity and, under subsequent processing (such as bending or stamping) or changes in ambient temperature, cannot withstand the stress, leading to brittle cracking and peeling.

Color-coated rolls

2.What are the effects of thermal stress in the storage and use environment?

When ambient temperature fluctuates drastically or frequently (e.g., large diurnal temperature range, sudden rain after prolonged exposure to sunlight), the metal and coating expand and contract at different rates.

This asynchronous expansion and contraction generates cyclic alternating stress at the interface between the coating and the substrate.

Over time, this stress gradually weakens the adhesion between the coating and the substrate, leading to interfacial fatigue and ultimately causing the coating to wrinkle, crack, and eventually peel off. This process is significantly accelerated for coatings that have not cured properly.

Color-coated rolls

3.What are the effects of condensation and corrosion?

When the surface temperature of the pre-coated steel coil is lower than the ambient dew point temperature, water droplets will condense on the surface.

If the coating itself has porosity, microcracks, or adhesion defects (which are likely caused by temperature issues during production), moisture will penetrate to the interface between the coating and the substrate.

Moisture acts as a "wedge" at the interface, reducing adhesion and, more importantly, triggering electrochemical corrosion of the base metal. The corrosion products expand in volume, generating significant internal stress that directly "lifts" the coating, causing blistering and peeling.

Color-coated rolls

4.What are the consequences of improper temperature during the production (baking and curing) process?

Uneven curing oven temperature, improper settings, unstable belt speed

Inherently weak adhesion, incomplete curing (softening), or over-baking (brittleness)

 

5.How can we avoid or analyze such problems?

Optimize production process: Strictly control the temperature profile of the baking oven (including the preheating zone, curing zone, and cooling zone) to ensure complete and proper curing of the coating.

Improve storage conditions: Color-coated rolls should be stored in a cool, dry, and well-ventilated indoor environment, avoiding direct sunlight, rain, and extreme temperatures.

Standardize construction and use: During processing and installation, avoid causing localized high-temperature damage to the coating. Consider the thermal environment of the location of the color-coated panels during building design.

Problem analysis: When coating peeling occurs, professional testing should be conducted, such as:

Adhesion testing (cross-cut test, tensile test) to determine the initial adhesion of the coating.

Differential scanning calorimetry (DSC) to analyze the glass transition temperature (Tg) and degree of curing of the coating to determine whether the curing process was sufficient.

Microscopic morphology analysis (e.g., electron microscopy) to observe the peeling interface and determine whether it is cohesive failure or adhesion failure.