SPCC Cold-Rolled Carbon Steel Plate

Aug 07, 2025 Leave a message

SPCC Cold-Rolled Carbon Steel Plate (JIS G 3141)
SPCC (Steel Plate Cold Commercial) is a cold-rolled low-carbon steel plate specified in the Japanese Industrial Standard (JIS). It is widely used in stamping, bending, welding, and other processing applications. Below is detailed information about SPCC:

1. Standard and Grade Comparison
Standard Corresponding Grade Similar Grade (Other Countries)
JIS G 3141 SPCC China: SPCC (GB/T 5213)
US: ASTM A1008 CS Type B
Europe: DC01 (EN 10130)
JIS G 3131 SPHC (Hot-Rolled Low-Carbon Steel) China: SPHC (GB/T 5213)
Note: SPCC is a cold-rolled steel plate, while SPHC is a hot-rolled steel plate. The two differ in surface quality and processing performance.

2. What is the chemical composition (according to JIS G 3141)?
Elements: C (Carbon) Mn (Manganese) P (Phosphorus) S (Sulfur) Others
Content (%): ≤0.12 ≤0.50 ≤0.040 ≤0.045 Trace
Characteristics: Low carbon, low alloy, with good plasticity and weldability, but low strength.

3. What are the mechanical properties (JIS G 3141)?

Performance Parameters Typical Values Notes
Tensile Strength (Rm) 270-410 MPa Low strength, suitable for stamping.
Yield Strength (Rp0.2) ≥140 MPa May be lower in the annealed state.
Elongation (A50mm) ≥28%-34% Thinner thickness increases elongation.
Hardness (HRB) 40-75 Hardness decreases after annealing.
Bending Properties 180° bend without cracks Suitable for bending and stamping.
Note: Mechanical properties are affected by material thickness and annealing conditions. Specific data should be referenced in the supplier's report.

4. Common Applications

Stampings: Electrical housings, automotive parts, hardware

Sheet Metal Processing: Chassis, brackets, covers

Welded Structural Parts: Low-stress welds (be mindful of deformation)

Surface Treatment Base: Electroplating, spray coating, galvanizing (such as SECC)

5. Surface Treatment and Classification
Surface Type Code Features Applications
Glossy SPCC-SD Smooth, scale-free High-precision stamping
Matte SPCC-MAT Slightly rough, suitable for spray coating General sheet metal
Galvanized SECC Enhanced rust resistance Chassis, housings

spcc plate

6. Comparison with Similar Materials
Material Standard Features Applications
SPCC JIS G 3141 Cold-rolled, smooth surface, good plasticity Stamping, bending
SPHC JIS G 3131 Hot-rolled, rough surface, slightly higher strength Structural parts, non-precision machining
SECC JIS G 3313 Galvanized SPCC, corrosion-resistant Chassis, outdoor components
7. What are the purchasing and processing considerations?
Thickness Range: Commonly available from 0.3mm to 3.0mm, with customization required for ultra-thin or extra-thick sheets.

Annealed: Softer after annealing, suitable for deep drawing; slightly higher strength in the hard (unannealed) state.

Welding: Spot welding and arc welding are acceptable, but heat input must be controlled to prevent deformation.

Rust Prevention: SPCC is uncoated and susceptible to rust, requiring oiling or electroplating (such as SECC).

Summary: SPCC is an economical cold-rolled, low-carbon steel sheet suitable for stamping, bending, and other processes, but requires careful rust prevention. For higher strength or corrosion resistance, consider alternative materials such as SPCD (for stamping) and SECC (galvanized).