Why does the coating have poor adhesion and easily fall off?

Oct 15, 2025 Leave a message

Why does the coating have poor adhesion and easily fall off?

Incomplete pretreatment may result in residual oil or scale on the substrate.

Excessive impurities (such as iron and copper ions) in the plating bath may affect deposition quality.



How can I fix "pinholes" (small pits) on the surface of the coating?

Check the plating bath for oil contamination. Remove the oil and add an anti-pinhole agent.

Ensure sufficient activation before plating to avoid an oxide film on the substrate.


Why is the coating partially blackened or rough (burned)?

Local current density is too high (such as at sharp corners of a part). Adjust the hanger or reduce the overall current.

The zinc ion concentration in the plating bath is too low; add the main salt.


What should I do if the coating lacks gloss and appears dull?

The brightener concentration is too low; add more in proportion.

The plating bath temperature is too high or the pH value is off-standard; adjust the parameters.


Why is there no coating (skip plating) in deep holes or grooves on a part?

Uneven current distribution may result; add a displacement agent. The design of the hanger is unreasonable, and the deep hole is not in contact with the current. The position of the hanger needs to be adjusted.