Why Coating Weight Matters
Popular specifications are in short supply!
click to get the specification sheet!
Galvanizing protects steel by applying a layer of zinc, which acts as a barrier against corrosion. The thicker the zinc coating, the longer the steel can withstand environmental exposure before rusting.
Coating weight is expressed as the total amount of zinc applied to both sides of the steel sheet, measured in ounces per square foot (oz/ft²) or grams per square meter (g/m²). This isn't just an abstract measurement; it directly translates into performance.
Higher coating weight equals a thicker zinc layer and greater corrosion resistance
Lower coating weight equals a thinner zinc layer and cost savings when less protection is required
The key is matching the coating weight to the environment and service life expectations of the end product.

G60 galvanized steel has a total zinc coating weight of 0.60 oz/ft², split across both sides of the sheet. That equals about 0.30 oz/ft² per side.
Typical thickness of zinc layer: roughly 0.3 mils per side
Corrosion resistance: adequate for indoor environments and many controlled outdoor conditions
Common applications: HVAC ductwork, interior building products, office furniture, and general manufacturing where exposure to moisture and weather is limited
G60 strikes a balance between protection and cost, making it a practical choice for buyers who don't require the maximum lifespan of a heavier coating.
G90 galvanized steel carries a total zinc coating weight of 0.90 oz/ft², or about 0.45 oz/ft² per side.
Typical thickness of zinc layer: about 0.6 mils per side
Corrosion resistance: stronger than G60, especially in environments with higher humidity, outdoor exposure, or frequent condensation
Common applications: roofing, siding, outdoor panels, structural components, agricultural equipment, and other uses where long-term durability is critical
The heavier zinc coating provides added insurance against rust, which is why G90 is often specified in construction and outdoor applications.

- Industries and Applications
|
Industry / Sector |
G60 Applications |
G90 Applications |
|
Automotive and Transportation |
Interior panels, non-exposed components |
Exterior parts requiring enhanced corrosion resistance |
|
Construction and Building Products |
Interior framing, studs, ceiling grids |
Roofing panels, siding, flashing, gutters |
|
HVAC and Ductwork |
Standard ducts, indoor systems |
Rooftop units, ductwork exposed to outdoor air |
|
Appliances and Furniture |
Washers, dryers, shelving, office furniture |
Outdoor enclosures, toolboxes, storage products |
|
Agriculture and Industrial Equipment |
Indoor machinery housings |
Fencing, silos, irrigation systems, exposed equipment |


