Will cold-rolled coils deform during low-temperature storage?

Jan 28, 2026 Leave a message

1.What is the core principle?

Properties of Steel: All metals exhibit the physical property of "thermal expansion and contraction." Steel contracts as the temperature decreases.

Special Characteristics of Cold-Rolled Coils:

Immense Integrity: A single cold-rolled coil can weigh tens of tons, forming a tightly wound, monolithic metal structure.

Existence of Residual Stress: Cold rolling is a plastic deformation process, resulting in complex residual stresses within the rolled steel coil. Although most of these stresses are eliminated through annealing and other treatments before shipment, they may still remain.

Anisotropy: Slight differences exist in the mechanical and thermal properties along the rolling direction (length) and radial direction (thickness direction of the coil).

cold-rolled coil

2.What are the key factors that cause deformation?

Temperature difference across the cross section (core vs. outer coil):

Most dangerous scenario: When the ambient temperature drops suddenly (e.g., from a high-temperature summer warehouse to a -20°C cold storage, or from a long period of outdoor storage in winter to a suddenly warm workshop), the outer coil of the steel coil will rapidly cool and shrink, while the large inner core, due to thermal inertia, will change temperature slowly.

Consequence: The outer coil attempts to shrink but is restrained by the inner "hot core," while the inner core is "pulled" by the outer coil. This uneven shrinkage generates enormous thermal stress inside the steel coil. When this stress is superimposed on the steel's original residual stress and exceeds the material's yield strength, plastic deformation occurs, causing the coil's circular cross section to lose its roundness, becoming elliptical or exhibiting localized "flattening." This is called "cold shrinkage deformation."

Temperature difference along the length:

If there is a localized cold source (e.g., a cold air vent directly facing one end of the steel coil) or heat source within the warehouse, causing one end of the steel coil to be cold and the other hot, uneven shrinkage along the length can also cause bending or warping.

cold-rolled coil

3.How to safely conduct low-temperature storage?

Control the rate of temperature change: Avoid sudden cooling and heating. If it is necessary to move the steel coil into a low-temperature environment, it should be done as slowly as possible, allowing the entire coil to change volume uniformly and synchronously, minimizing the temperature difference between the inside and outside.

Maintain a uniform and stable temperature: Ensure a uniform temperature field within the storage environment, with no direct exposure of the steel coil to cold drafts. A stable low-temperature environment is safer than frequent temperature fluctuations.

cold-rolled coil

4.How to use the correct storage method?

Preferably, store the coil upright (in a coil position): This is the most recommended storage method. The coil's axis is perpendicular to the ground, preventing elliptical deformation due to its own weight and facilitating airflow and more even temperature distribution.

If storing flat: Ensure sufficient quantities of high-strength V-shaped saddles or specialized wooden blocks are used to support the coil at specific locations (usually around 1/4 of its width), and regularly check the support condition.

 

5.How to conduct an assessment and consultation in advance?

For precision cold-rolled coils with strict tolerance requirements (such as those used for automotive exterior panels), it is best to consult with the material supplier or metallurgical engineer to assess the material's performance at specific low temperatures before planning long-term cryogenic storage.