1.Why not recommended?
Destroying the core of corrosion protection: Sandblasting directly wears away and removes this valuable zinc layer, depleting its original long-term corrosion protection.
Not worth the cost: Galvanizing itself is a cost. Sandblasting it away not only wastes the cost of the galvanizing, but also loses its corrosion protection unless stronger protective measures are followed up (see below).
Surface treatment challenges: The sandblasted surface represents a fresh, activated steel substrate, which is highly susceptible to rapid rusting in the presence of air and requires immediate subsequent treatment (such as painting).

2.When would you consider sandblasting galvanized coils?
Preparing for subsequent painting (most common scenario):
Scenario: When applying high-performance paint or powder coatings to galvanized parts, a surface with a certain degree of roughness is required for optimal coating adhesion. Smooth galvanized surfaces have poor adhesion.
Purpose: Abrasive blasting is not intended to "clean" but rather to "roughen" the steel surface, creating a clean surface with a specific anchor grain (roughness).
Removing severe galvanizing defects or contaminants:
Scenario: The galvanized surface contains stubborn contaminants that are difficult to remove by other methods, heavy zinc slag, or severely uneven areas.
Purpose: Abrasive blasting is used to achieve a uniform, clean substrate surface.
Repairing old galvanized parts:
Scenario: The old galvanized part has localized zinc damage and rust.
Purpose: Completely remove all rust and old coatings in preparation for repainting or regalvanizing.

3.If sandblasting is necessary, what special process is required?
Choosing the right abrasive (the most critical step):
Absolutely avoid: Metal abrasives (such as steel grit and steel shot) and high-hardness minerals (such as brown corundum). These can instantly remove the zinc layer and damage the steel substrate.
Recommended: Flexible, low-hardness non-metallic abrasives.
Plant-based materials: Walnut shells, corn cobs, etc. These materials have a moderate hardness and can effectively remove contaminants without significantly damaging the dense zinc layer.
Plastic-based materials: Plastic beads and plastic sand. These are ideal for processing soft metals (such as aluminum and zinc), providing good cleaning results while minimizing substrate damage.
Soft minerals: Dolomite, calcium carbonate, etc.
Strictly control process parameters:
Air pressure: Use low air pressure.
Blast angle and distance: Avoid spraying at a vertical 90-degree angle; use a more inclined angle and a longer distance.
Operator skills: Experienced operators are required who can judge the degree of treatment required to achieve a clean surface without excessively removing the zinc layer.
Immediately perform follow-up treatment:
Sandblasting exposes the steel substrate, requiring subsequent painting or re-protection treatment within 4 hours (or less depending on ambient humidity). Otherwise, rust will occur rapidly.

4.What is a better alternative?
Light blasting: This is a very light treatment using the soft abrasives mentioned above, intended only to increase surface roughness.
Chemical conversion treatment (e.g., phosphating, passivation): This treatment does not damage the zinc layer but instead forms a conversion film that enhances paint adhesion.
Mechanical grinding/brushing: This surface preparation, using sandpaper, a wire brush, or a specialized "brushing" tool, is easier to control than blasting.
Using a "galvanized primer": Many coatings are now specifically designed for direct application to smooth galvanized surfaces. They offer excellent adhesion and can eliminate the need for complex surface preparation.
5.What are the main risks of sandblasting?
It destroys the zinc anti-corrosion layer, causing the base material to rust easily and waste costs.

