DC01 DC02 DC03 DC04 DC05 Cold Rolled Steel Coil and Strip

Aug 29, 2025 Leave a message

What Are DC01 to DC05 Cold Rolled Steel Grades?

Mechanical Property Ranges per EN 10130

EN 10130 specifies the following mechanical properties for thicknesses up to 3.0 mm (typical values quoted at 0.7 to 2.0 mm thickness):

Grade Yield strength Rp0.2 (MPa) Tensile strength Rm (MPa) Elongation A80 min (%) Typical use
DC01 130-260 270-410 28 Simple bending and forming
DC03 130-210 270-370 34 Moderate forming
DC04 130-210 270-350 38 Deep drawing
DC05 120-180 270-330 40 Severe deep drawing

Forming Behaviour and Surface Quality

As the grade number increases, the carbon content and yield strength decrease while elongation and strain-hardening capacity improve. DC04 and DC05 are supplied with guaranteed r90 (normal anisotropy) and n90 (strain hardening exponent) values when tested in accordance with EN 10130, which makes them predictable in multi-stage drawing operations. The surface of DC grades is produced to defined classes - DC01A (smooth), DC01B (bright) and DC01C (matte) - specified in EN 10130 for the different surface appearance requirements of painted or visible parts.

Grade Selection Guidance

Use DC01 for simple bending, beading, coining and shallow forming. Use DC03 where the part requires moderate stretching. Use DC04 for deep drawn parts such as automotive panels, housings and kitchenware. Use DC05 where the drawing ratio is high or where surface quality after forming is critical, such as exposed automotive body panels. Edge condition (untrimmed, trimmed, or slit edge) and dimensional tolerances should be agreed against EN 10131.

Frequently Asked Questions

Is DC01 stainless steel? No. DC01 is a cold-rolled low-carbon steel grade covered by EN 10130; it is not stainless steel. Stainless steels contain a minimum of about 10.5% chromium and are specified in standards such as EN 10088, which is a completely different material family.

What is the former designation of DC01? DC01 was previously designated St12 in DIN 1623 and FeP01 in older European nomenclature. The former designation of DC04 is St14.

Can DC01 be used for deep drawing? DC01 is suitable for simple forming operations such as bending and shallow drawing. For demanding deep drawing operations DC04 or DC05 should be selected because of their higher elongation and better anisotropy values.

What is the difference between DC03 and DC04? Both grades have similar yield and tensile strength ranges, but DC04 guarantees a higher minimum elongation (38% versus 34%) and better deep drawing parameters, so it is preferred for more severe deformation.

Is DC05 suitable for exposed automotive panels? Yes. DC05 combines low yield strength with high elongation and good surface quality classes, which is why it is widely specified for complex exterior body panels that are painted after forming.