Galvanized Rectangular Tube

Sep 16, 2025 Leave a message

Galvanized Rectangular Tube
Galvanized rectangular tube is a type of steel tube with a rectangular cross-section that has been galvanized. Due to its excellent performance and wide application, it occupies a significant position in the steel market. The following is a detailed introduction:
Definition and Manufacturing Process
Definition: Galvanized rectangular tube is a hollow steel tube with a rectangular or nearly rectangular cross-section. Its inner and outer surfaces are typically coated with a zinc layer for corrosion protection.
Manufacturing Process: The steel undergoes pre-treatment processes such as cutting and forming to obtain rectangular tubes of the desired dimensions. A zinc layer is then applied to the tube surface through hot-dip galvanizing, electroplating, or thermal spraying. Finally, the tube is cooled and inspected to ensure that dimensional accuracy and surface quality meet standards.
Performance and Characteristics
Corrosion Resistance: The zinc layer effectively isolates the tube from external corrosive media, significantly improving its corrosion resistance. Hot-dip galvanized tubes can withstand salt spray tests for up to 720 hours without red rust.
High Strength: Rectangular steel tubes inherently possess high bending strength and load-bearing capacity. The galvanizing treatment further enhances their strength with the zinc layer. Good Toughness: The zinc coating has excellent toughness, effectively resisting external forces such as impact and compression.
Aesthetic Appearance: The galvanized coating imparts a silvery-white luster to the steel pipe surface, creating a smooth, bright appearance and high decorative value.
Specifications
Side Length: Common side lengths range from 16mm×16mm to 400mm×400mm, with various side length combinations available, such as 20mm×30mm and 25mm×40mm.
Wall Thickness: Common wall thicknesses range from 0.4mm to 16mm, depending on the size and application requirements. For wall thicknesses up to 10mm, the wall thickness deviation must not exceed plus or minus 10% of the nominal wall thickness; for wall thicknesses greater than 10mm, the deviation is plus or minus 8% of the wall thickness. Length: The usual delivery length is 4000mm to 12000mm, with 6000mm and 12000mm being the most common. Short lengths of not less than 2000mm and non-fixed length products are also allowed.