How to ensure uniform coating thickness for color coated coils to improve corrosion resistance?

Jul 25, 2025 Leave a message

1.How to pre-treat the substrate?

Substrate thickness and flatness control
Select substrates with a thickness deviation of ≤±5μm to avoid "relatively thin coating on thick substrates and relatively thick coating on thin substrates" during coating due to uneven thickness of substrates.
Remove the wave shape, sickle bend and other deformations on the surface of the substrate, ensure the flatness of the substrate through the leveling machine, and reduce the problem of uneven roller pressure during coating.

Surface cleaning and roughening
Degreasing: Electrolytic degreasing or spray degreasing is used to ensure that the oil removal rate on the substrate surface is ≥99%, avoiding poor adhesion and insufficient thickness of local coatings caused by oil stains.
Pickling/phosphating: Remove oxide scale and rust to form a uniform phosphating film, which not only enhances the adhesion of the coating, but also ensures the "leveling consistency" of the coating through uniform surface roughness.

Color coated coil

2.How to stably control the coating state?

Viscosity and solid content: The viscosity of the coating needs to be stable within the process range. Viscosity fluctuations will lead to differences in coating amount. Real-time monitoring can be performed through an online viscometer, and solvent or coating adjustment can be automatically added.
Pigment dispersion: The pigment in the coating needs to be fully dispersed to avoid particle agglomeration, which will cause "local jamming" of the coating roller and cause fluctuations in coating thickness.

Color coated coil

3.How to adjust roller coating parameters?

Pressure between the coating roller and the substrate: The pressure needs to be uniform. The zoned pressure control system can be used to ensure that the pressure at each point on the roller surface is consistent to avoid excessive edge pressure resulting in a thin coating.
Roller speed ratio: The ratio of the coating roller speed to the substrate speed needs to be stable. Ratio fluctuations will cause changes in the amount of coating transfer. The roller speed and substrate speed are synchronously controlled by a servo motor, and the deviation is controlled within ±0.1%.
Surface condition of the coating roller: The coating roller (such as rubber roller, steel roller) needs to ensure uniform surface hardness, no scratches or wear, and regular grinding and repair to avoid "striped" thickness deviation of the coating due to roller surface defects.

Color coated coil

4.How to avoid thickness affected by uneven curing?

Curing furnace temperature uniformity
The composite heating method of hot air circulation + infrared temperature measurement is used to ensure that the lateral temperature difference in the furnace is ≤±5℃. For example, when the polyester coating is cured, local overheating will cause the coating to cure prematurely, hinder the flow of the surrounding coating, and form "local thickness"; insufficient temperature will cause poor leveling of the coating and "orange peel-like" uneven thickness.
Substrate operation stability
The substrate in the curing furnace needs to maintain stable operation to avoid local uneven heating due to substrate deviation, which will affect the thickness consistency of the coating after curing.

 

5.How to reduce mechanical errors?

Mechanical precision control of coating machine
Parallelism of coating roller and substrate: through laser calibration, ensure that the verticality deviation between the axis of coating roller and the running direction of substrate is ≤0.1mm/m, to avoid "one side thick and one side thin" due to insufficient parallelism.
Flatness of coating scraper: The straightness deviation of scraper blade is ≤0.05mm/m, to avoid "wavy" coating due to uneven scraper.
Regular maintenance and calibration
Check the wear of coating roller bearing every week to avoid roller surface jumping due to excessive bearing clearance;
Calibrate the thickness control system of coating machine with laser thickness gauge every month to ensure that the deviation between set thickness and actual thickness is ≤±1μm.