1.What problems does weather resistance testing mainly solve?
Evaluate the service life of coatings in specific environments;
Compare the differences in weather resistance of different coating formulations (such as primer, topcoat type, thickness);
Verify whether the product meets industry standards or customer requirements (such as color-coated coils for construction must meet the requirements of 10-20 years of outdoor use).

2.What are the natural exposure testing procedures?
The natural exposure test is to expose the color-coated coil sample to a typical natural environment and directly bear the effects of real climatic conditions. It is the test method that is closest to the actual use scenario. However, the disadvantage is that the cycle is long (usually takes several years or even more than ten years) and is limited by the regional climate.
Test site selection
Representative climate zones should be selected based on the product's target use area.
Exposure method
The most commonly used exposure is 45° south-facing (simulating the typical installation angle of building exterior walls and roofs) to ensure that the sample receives the maximum amount of sunlight;
Some scenes will use "horizontal exposure" (such as roof plane) or "vertical exposure" (such as vertical wall installation).
Test cycle and test items
Cycle: short-term (3 months, 6 months), medium-term (1 year, 2 years), long-term (5 years, 10 years or more), regular sampling and testing are required;
Test items:
Appearance changes: observe whether there is discoloration, powdering, cracking, blistering, peeling, etc., and rate according to standards;
Performance changes: measure gloss retention, color difference, and coating adhesion.

3.What are the steps for artificial accelerated aging testing?
Artificial accelerated aging testing uses laboratory equipment to simulate key aging factors in the natural environment (such as ultraviolet rays, high temperature, high humidity, rain, etc.), shorten the test cycle (usually several days to several months), and quickly evaluate the weather resistance of the coating.
Xenon lamp aging test (most commonly used)
Principle: Use a xenon lamp to simulate the full spectrum of sunlight, combined with a water spray/condensation device to simulate rain and high humidity, close to natural aging conditions.
Core parameters:
Irradiance;
Blackboard temperature;
Humidity;
Cycle period.

4.What are the key evaluation indicators?
Appearance changes
Discoloration: color difference from the standard sample
Powdering: degree of pigment/resin shedding on the coating surface (0: no powdering, 5: severe powdering)
Cracking: crack size and density (0: no cracks, 5: large cracks)
Blistering: bubble size and density (0: no bubbles, 5: dense and large bubbles)
Foaming: Bubble size and density (level 0 means no bubbles, level 5 means dense and large bubbles)
Performance change: Gloss retention rate: gloss after test / initial gloss × 100%
Adhesion: the bonding strength between the coating and the substrate (tape peeling after cross-cutting, no peeling at level 0, complete peeling at level 5)
5.What difference does the choice of test standard make?
Color-coated steel coils for construction: often refer to GB/T 12754-2019 (color-coated steel sheets and strips), ASTM A755;
Color-coated steel coils for household appliances: refer to ISO 10684, GB/T 13448;
Internationally used: ISO series (such as ISO 11341), ASTM series (such as ASTM G155).

