Can the oxide layer on the surface of galvanized coil be welded?

Nov 07, 2025 Leave a message

1.Why is it necessary to remove the surface oxide layer?

Porosity:

Zinc has a melting point of approximately 420°C and a boiling point of approximately 907°C.

Steel has a melting point of approximately 1500°C, which is also within the melting point range of ordinary welding wire.

Under the high temperature of an electric arc, zinc in the weld area rapidly evaporates and boils, producing zinc vapor. If this vapor cannot escape from the molten pool in time, it will form numerous pores after the weld metal solidifies, severely weakening the weld's strength and density.

Weld Spatter:

The intense evaporation of zinc disrupts the stability of the electric arc and causes molten metal droplets to splatter everywhere, resulting in an unsightly weld and increasing cleaning workload.

Lack of Fusion and Cracks:

The oxide layer and contaminants on the surface hinder good fusion between the base metal and the filler metal, easily leading to lack of fusion defects.

Furthermore, zinc penetration into the weld grain boundaries forms brittle phases, increasing the weld's susceptibility to hot cracking.

galvanized coil

2.How to perform a thorough pre-welding cleaning?

Mechanical Cleaning (Most Common):

Angle Grinder + Grinding Wheel/Wire Wheel: This is the most effective and thorough method. Grinding wheels or louvered blades can quickly remove the oxide and zinc layers. Stainless steel wire wheels also work well and cause less damage to the substrate.

Files, Sandpaper: For small areas or corners, coarse sandpaper or files can be used for polishing.

Chemical Cleaning:

Specialized welding cleaners or diluted acidic solutions (such as hydrochloric acid) can dissolve zinc oxide and the passivation film, but it is essential to rinse thoroughly with water and allow to dry completely afterwards. Otherwise, residual chemicals can create new pores and toxic gases during welding. Chemical methods are generally not recommended for non-professionals.

galvanized coil

3.How to choose the right welding method and process?

Welding Method Selection:

Gas Shielded Welding (GAW): Especially MAG welding, is the most commonly used method. Using an appropriate shielding gas (such as an Ar+CO₂ mixture) and welding wire can achieve good weld quality.

Manual Arc Welding: Can also be used, but it produces more spatter and requires the selection of suitable basic electrodes.

Tungsten Inert Gas (TIG) Welding: Provides the purest weld with high quality, but it also requires the most thorough pre-weld cleaning and is more expensive.

Process Parameter Adjustment:

Reducing Current: Compared to ordinary steel plates of the same thickness, the current should be reduced by 10%-15% when welding galvanized steel. This helps reduce zinc burn-off and evaporation.

Increasing Welding Speed: Fast welding reduces heat input, thereby reducing the heat-affected zone and allowing zinc vapor more time to escape.

Using Short Arc Operation: Maintaining a shorter arc length helps stabilize the arc and reduces air intrusion.

galvanized coil

4.How to strengthen post-weld treatment and protection?

Weld Cleaning: After welding, slag and spatter around the weld should be removed.

Corrosion Protection: The welding process damages the galvanized layer of the weld and surrounding area, rendering it ineffective against corrosion. These areas must be re-treated with anti-corrosion measures, such as:

Spraying with zinc-rich paint (the most common and effective method).

Using cold-dip galvanizing coatings.

 

5.How to ensure safety?

Ventilation: Welding must be performed in an extremely well-ventilated environment, preferably using a powerful local exhaust system (such as a fume extractor) to remove welding fumes from the source.

Respiratory Protection: Welders must wear qualified dust and fume respirators.

Eye Protection: Wear a suitable welding mask.

Protective Clothing: Wear fire-resistant clothing and gloves to prevent burns and UV damage.