1.What are the steps for an outdoor natural sun exposure test?
Environmental Conditions: Completely realistic outdoor climate.
Typical Locations:
Arizona/Florida Exposure Zones (USA): Representing hot, dry desert climates (strong UV radiation, high temperatures, large temperature differences, low humidity) and hot, humid maritime climates (strong UV radiation, high temperatures, high humidity, salt spray). Florida is an internationally recognized benchmark for harsh testing.
Other representative climates: Such as industrial pollution areas, high-altitude areas with strong UV radiation, etc.

2.What are the steps for a xenon lamp aging test?
Standards: Primarily conforming to ASTM G155, ISO 16474-2, and GB/T 1865.
Core Environmental Condition Cycles (using common cycles as examples):
Illumination Phase:
Light Source: Filtered xenon arc lamp.
Irradiance: Typically controlled at 0.35 or 0.65 W/m² @ 340nm (monitoring key intensity in the UV band).
Blackboard Temperature: Typically 63℃ ± 3℃ or higher (simulating material surface temperature).
Chamber Temperature: Approximately 40℃.
Relative Humidity: Typically 50% ± 5% or lower (low humidity is typically controlled during illumination).
Duration: E.g., 102 minutes.
Spray/Dark Stage:
Spray: Simulates rainfall, thermal shock, and condensation. Spray with deionized water for 18 minutes.
Temperature/Humidity: This stage may lower the temperature and increase the humidity to simulate nighttime or condensation conditions.

3.What are the steps for ultraviolet fluorescence aging test?
Primarily simulates the destructive effects of ultraviolet light, condensation, and moisture. It is particularly effective for UV-sensitive materials but lacks visible and infrared spectra.
Standards: Primarily follows ASTM G154 and ISO 16474-3.
Core Environmental Condition Cycling (using a common cycle as an example):
UV Irradiation Stage:
Light Source: UVA-340 lamp (optimally simulates the ultraviolet range of sunlight).
Temperature: Typically 60°C (blackboard temperature).
Duration: E.g., 8 hours.
Condensation/Wetness Stage:
Principle: Heated water tank generates steam, which condenses on the back of the sample to form a liquid water film.
Temperature: Typically 50°C.
Relative Humidity: 100% condensation.
Duration: E.g., 4 hours.
Cycling: The above UV and condensation stages are continuously cycled.

4.What are the steps for corrosion resistance testing?
Salt Spray Test:
Standards: ASTM B117, ISO 9227, GB/T 10125.
Conditions: 5% NaCl solution, constant temperature 35℃, continuous spraying. Used to evaluate the corrosion resistance of coating systems and their resistance to the spread of corrosion at scratches.
Cyclic Corrosion Test (More Severe, More Realistic):
Standards: Such as ASTM D5894, ISO 20340.
Conditions: Cycles through multiple stages including salt spray, drying, humidity, and low temperature, providing a more comprehensive test of the coating system than a single salt spray test.
5.What are the conclusions and industry practices?
Test Selection: High-quality color-coated coils (especially for construction) typically undergo a combination of xenon lamp aging and salt spray/cyclic corrosion testing to comprehensively evaluate their weather resistance and corrosion resistance.
Performance Claims: Suppliers often specify test results, such as: "Passed 2000 hours of xenon lamp aging (ASTM G155), gloss retention >80%, color difference ΔE < 2.0" or "Passed 3000 hours of salt spray test, no red rust."
Related to Actual Lifespan: Accelerated test hours cannot be directly converted into years of outdoor use, but they provide a reliable performance benchmark. Generally, products that perform well in standard tests are considered to have a longer lifespan in real-world outdoor environments.

