What is the surface coating hardness of galvanized coil?

Oct 11, 2025 Leave a message

1.How hard is the zinc layer itself?

The microhardness of pure zinc is approximately 70-120 HV. By comparison, a human fingernail has a hardness of about 20-30 HV, while a good knife can exceed 600 HV.

This means that a pure zinc layer can be easily scratched by hard objects such as knife tips or grit. This is why special care must be taken to protect the surface of galvanized coils during transportation and processing.

Galvanized Coil

2.How does the hardness of the substrate affect the surface hardness of the galvanized coil?

Galvanized coils are galvanized on a cold-rolled or high-strength substrate. The "hardness" we perceive when touching or scratching with ordinary tools is actually the combined effect of the substrate and the zinc layer, with the hardness of the substrate being the primary factor.

The substrate's hardness is much higher than the zinc layer. For example, the hardness of ordinary cold-rolled steel is typically above 120-180 HV, and high-strength steel is even higher.

Conclusion: The dent and deformation resistance of galvanized coils depends primarily on the mechanical properties of the substrate steel.

Galvanized Coil

3.How does the type of galvanizing process affect the hardness of galvanized coil?

Hot-dip galvanizing: The resulting coating structure may consist of a pure zinc layer and an underlying zinc-iron alloy layer. The zinc-iron alloy layer (such as the gamma layer) is harder and more wear-resistant than the pure zinc layer, but also more brittle. In hot-dip galvanizing, if the process is properly controlled and the alloy layer is well developed, the surface wear resistance will be even better.

Electrogalvanizing: The coating is almost pure zinc, resulting in a relatively softer surface and more susceptible to scratching.

Galvanized Coil

4.How do alloying elements in the zinc layer affect the hardness of galvanized coil?

In some specialized galvanized products, such as Galvanneal (zinc-iron alloy coating), heat treatment transforms the entire coating layer into a zinc-iron alloy. This coating, lacking a pure zinc layer, is significantly harder than conventional hot-dip galvanizing, making it extremely wear-resistant and providing an excellent base for subsequent coating. Its microhardness can reach 250 HV or even higher.

 

5.How to measure and test "hardness"?

Macrohardness (Substrate Hardness)

Test Method: Pencil hardness or abrasion resistance tests are typically used to evaluate the scratch and wear resistance of the coating itself.

Application: This is more useful for evaluating the resistance of galvanized coils to surface damage during transportation and processing. The pencil hardness of conventional hot-dip galvanized steel is typically between B and 1H, while alloyed galvanized steel can reach 1H to 3H or higher.

Microhardness (Coating Hardness)

Test Method: A microhardness tester is used to test a cross-section of the coating, providing a specific hardness value (such as HV or HK).

Application: Primarily used for process research and quality analysis, rather than routine inspection.