Can galvanized coils be laser-cut with small holes?

Nov 03, 2025 Leave a message

1.What are the advantages of laser cutting small holes in galvanized coils?

High precision and efficiency: Laser cutting can quickly and accurately produce holes with very small diameters (even smaller than the plate thickness) and smooth hole walls, making it ideal for mass production.

Non-contact processing: The laser cutting head does not contact the material, avoiding mechanical stress and preventing indentations or scratches on the galvanized layer.

High flexibility: Programmable cutting allows for the easy processing of small holes of any shape and arrangement, making it ideal for modern automated production lines.

galvanized coil

2.What are the characteristics and solutions for zinc dross adhesion (slag buildup)?

Problem Description: The melting point of the zinc layer on the surface of galvanized coils (approximately 420°C) is much lower than that of the steel substrate (approximately 1500°C). During laser cutting, the zinc layer melts and vaporizes rapidly. Some of the molten zinc cannot be completely blown away by the assist gas, splashing and adhering to the lower edge of the hole wall, forming hard zinc dross. This is particularly noticeable when cutting small holes due to the confined space and poor gas flow.

Solution:

Use high-purity, high-pressure assist gas: Nitrogen (N₂) is preferred. Nitrogen is an inert gas that prevents the material from oxidizing at high temperatures and blows away the molten zinc, thus minimizing zinc dross formation. The gas pressure needs to be adjusted according to the plate thickness and is typically required to be high (e.g., 15-20 Bar or higher).

Optimize laser parameters: including power, speed, frequency, and duty cycle. The optimal combination of parameters needs to be found so that the energy penetrates the steel plate just enough without over-melting the zinc layer. A pulse cutting mode with high peak power, low frequency, and high speed is typically used to reduce heat input.

Specialized piercing techniques are employed: For thick plates, avoid using ordinary explosive piercing; instead, use progressive pulse piercing, penetrating layer by layer to prevent excessive spatter in the initial stage.

galvanized coil

3.What are the signs and solutions for overheating/blackening of the lower surface?

Problem Description: When zinc vapor escapes from the bottom of the cut, improper parameters can cause overheating at the lower edge of the hole, resulting in blackening of the galvanized layer and affecting aesthetics and corrosion resistance.

Solution: This also requires optimizing gas and laser parameters. Ensure a stable auxiliary gas flow to effectively cool and remove molten material.

galvanized coil

4.What are the symptoms and solutions for poor hole roundness?

Problem Description: When cutting very small holes, if the start and end points do not align properly, or the speed is unstable, the hole may not be round.

Solution:

Use the "circumferential cutting" function: Many advanced laser cutting systems have a small hole circumferential cutting function. The laser beam rotates around the center to cut, rather than simply making a circular motion, resulting in a more perfectly round hole.

Adjust the cutting path: Optimize the programming to ensure the consistency and stability of the cutting path.

 

5.What are the key success factors?

Gas is key: High-purity nitrogen (≥99.99%) is strongly recommended as the auxiliary gas. Compressed air, due to its oxygen content, will cause oxidation and blackening of the cut edges, and is generally unsuitable for demanding applications. While oxygen can cut carbon steel quickly, it will completely burn away the galvanized layer and should never be used for precision cutting of galvanized coils.

Parameter optimization is crucial: There are no "one-size-fits-all" parameters; repeated testing and optimization are necessary based on your equipment brand, sheet thickness, zinc layer thickness, and hole size.

Equipment compatibility is essential: Use a high-quality laser (such as a fiber laser, which is excellent for cutting galvanized materials) and a stable gas supply system.

Focus position: The correct focus position is critical to hole quality and typically needs to be slightly below the sheet surface.

Professional operator: Experienced operators can quickly adjust parameters based on actual conditions and resolve unexpected problems.