DC01, DC03 And DC04 Cold-Rolled Steel: Key Differences

Jun 09, 2025 Leave a message

The DC grades are cold-rolled low-carbon steel grades defined in EN 10130, distinguished by their formability. This article explains the differences between DC01, DC03 and DC04.

 

Dx51d DC01 SPCC

 

1. DC01: The Basic Forming Grade

DC01 represents the basic grade of the DC steel family and is also known under the former designations St12 or FeP01. This grade can be used for simple forming operations such as bending, coining, beading and drawing.

 

2. DC03: Deep-Drawing Grade

DC03 is a mild low-carbon steel for cold forming with excellent deep-drawing capability under all types of deformation. It is suitable for forming requirements such as deep drawing and difficult profiling.

 

3. DC04: High-Formability Grade

DC04 has significantly better formability than DC01. It can withstand complex shaping and deep-drawing processes without cracking. DC01 is ideal for simple forming processes such as bending, shallow drawing and stamping; DC04 is specified where the part geometry demands maximum drawability.

 

4. The "CR4" Market Reference

In the UK market, DC01 mild steel is often referred to as CR4 (cold-reduced steel), commonly supplied in thicknesses from 0.9 mm up to 3 mm. CR4 is a market nickname for cold-reduced sheet, not a formal EN grade designation.

 

5. Selection Summary

Grade Formability Typical use
DC01 Basic Bending, embossing, beading, shallow drawing, stamping
DC03 Good Deep drawing, difficult profiling
DC04 Excellent Complex shaping, deep drawing without cracking

 

Send Your Requirements