1.What is the core reason for rust?
Air Humidity: When the relative humidity exceeds the steel's "critical humidity" (generally considered to be around 60%-70%), a thin, invisible water film forms on the metal surface, and electrochemical corrosion begins to occur rapidly. This problem is particularly pronounced during humid rainy seasons, in coastal areas, or near rivers.
Direct Contact with Water: Leaky warehouses, damp floors, condensation dripping from the ceiling (prone to large temperature differences between the inside and outside of warehouses in summer), or direct contact with damp ground can all lead to severe localized corrosion.
"Herringbone" Rust: If coils are stacked upright (with the axis perpendicular to the ground), rainwater or condensation may flow from the top into the gaps between the coil layers, forming a distinctive "Herringbone" shaped rust mark.

2.Does temperature difference and condensation affect corrosion of cold-rolled coils?
In regions with large diurnal or seasonal temperature differences, the surface temperature of steel may be lower than the air's dew point, causing water vapor in the air to condense into water droplets on the cold steel coil surface. This repeated "condensation-evaporation" process has a strong accelerating effect on corrosion.

3.Does contaminant affect the corrosion of cold-rolled coils?
Acidic substances: If the air contains acidic or saline pollutants such as sulfur dioxide, hydrogen sulfide, and chloride ions (especially in coastal areas or near chemical plants), they will dissolve in the water film, forming an electrolyte that greatly accelerates the corrosion rate. Chloride ions are particularly corrosive to steel.
Dust and impurities: Dust settling on the surface of steel coils may contain not only hygroscopic or corrosive particles, but also moisture absorbed through capillary action, creating a locally damp environment beneath the dust.

4.How do improper packaging and stacking practices affect the degree of rusting?
Damaged packaging: If the rust-preventive oil, rust-preventive paper, or plastic film packaging is damaged, it loses its protective function.
Improper stacking: Directly stacking on dirt or cement surfaces (without moisture-proofing) allows ground moisture to seep upwards. Overly dense stacking also hinders air circulation.
5.What preventative measures are there?
Warehouse Selection:
Use dedicated indoor warehouses; absolutely avoid open-air storage.
The warehouse should be airtight, rainproof, and moisture-proof. The floor should ideally be treated with moisture-proof materials (e.g., using moisture-proof dunnage, pallets, or other moisture-proof flooring materials).
Ideally, a temperature- and humidity-controlled warehouse can be used.
Temperature and Humidity Control:
Install thermometers and hygrometers for monitoring. Keep the relative humidity in the warehouse below 50% whenever possible.
During humid seasons, use dehumidifiers or ventilate during dry weather (ensure outdoor humidity is lower than indoor humidity before ventilating).
Avoid drastic temperature changes in steel coils within a short period to reduce the risk of condensation. Newly delivered steel coils should be allowed to acclimatize before unpacking (to prevent condensation from cold coils encountering warm air).
Stacking Management:
Use dunnage or pallets to maintain a distance of at least 10-20 cm between the bottom of the coils and the ground.
Ensure that the packaging (rust-preventive oil, vapor phase corrosion inhibitor/VCI, stretch film, etc.) is intact. For long-term storage, regularly inspect and re-oil. Stacking should not be too dense to ensure adequate air circulation.

