Surface scratch repair method of galvanized coil

Oct 17, 2025 Leave a message

1.How to deal with minor scratches (only the zinc layer surface is damaged, the steel base is not exposed)?

Passivation Treatment

Suitable for: Very minor scratches, primarily to prevent white rust from forming in the scratch itself.

Method: Use a dedicated chromium-free zinc passivation solution. Dip a soft cloth or brush in it and apply it evenly to the scratched area and surrounding areas. This will re-form a dense passivation film on the zinc surface, slowing corrosion.

Advantages: Simple and low-cost.

Disadvantages: Does not fill scratches and is ineffective on deep scratches.

Apply a special rust inhibitor/protective agent

Suitable for: Minor scratches requiring more protection than passivation.

Method: Use a commercially available "galvanized repair pen" or "zinc soldering pen," which contains a zinc-rich coating. Apply directly to the scratch.

Advantages: Convenient and quick, provides some electrochemical protection.

Galvanized Coil

2.How to deal with moderate scratches (the zinc layer is scratched and the steel base is exposed)?

Repair with Zinc-Rich Paint (Most Common and Effective Method)

Suitable for: Most scratches and scuffs where the substrate is exposed.

Method:

Surface Cleaning: First, thoroughly remove oil, impurities, and any existing oxides (red rust) from the scratched area with a solvent (such as alcohol or acetone). Lightly sand with fine sandpaper if necessary.

Coating: Use cold-dip galvanizing paint or zinc-rich primer. These paints contain a high concentration of zinc powder (typically over 90%) and form a zinc film upon drying.

How it works: This zinc film, like the original zinc coating, provides cathodic protection (sacrificial anode) to the steel substrate. The zinc powder corrodes preferentially, thus protecting the steel.

Paint Repair

Suitable Applications: Where corrosion protection is less demanding but a uniform appearance is essential.

Method: First, apply a zinc-rich primer for corrosion protection, then apply a topcoat of a paint similar in color to the galvanized coil.

Advantages: Provides a significant improvement in appearance.

Disadvantages: If the topcoat system is incomplete or damaged, corrosion protection will be reduced.

Galvanized Coil

3.How to deal with severe scratches (deep and wide, or scratches covering a large area)?

Professional Welding Repair (Uncommon, Highly Skilled)

Suitable for: Very deep defects or rare cases requiring structural reinforcement.

Method: Gas or arc welding with zinc alloy electrodes to fill the damaged area with zinc.

Warning: This process produces large amounts of toxic zinc oxide fumes and must be performed by qualified personnel under extreme ventilation and protective conditions. It is generally not recommended.

Replacement or Downgrade

From a quality control and cost perspective, for severely defective coils discovered during the production line or decoiling process, the most economical approach may be to mark the defect and downgrade it for use, or to remove the defective portion.

Galvanized Coil

4.How to prevent scratches?

During the lifting, transportation, uncoiling, processing, and storage of galvanized coils, please note the following:

Use appropriate lifting equipment (such as a dedicated C-hook) to avoid direct contact with the wire rope.

Keep the equipment rollers and guide plates clean and flat, free of hard objects such as welding slag and iron filings.

Operators must perform their duties in a standardized manner to avoid scratches from hard objects.

 

5.Can the restoration be done to the same perfect condition as the original intact galvanizing?

No repair method can achieve the perfect condition of the original intact galvanized layer. Its purpose is mainly to prevent further corrosion (red rust) of the scratched area and to improve the appearance to a certain extent.