Hot-dip galvanizing, also known as hot-dip galvanizing, is a widely used anti-corrosion metal coating process. The steel sheets and coils produced by the hot-dip galvanizing process mainly include pure hot-dip zinc (GI) and hot-dip galvanized (GA) ferroalloys. When the steel winds through the zinc pot, the surface coated with liquid zinc, the zinc layer crystallized in the natural solidification process, that is, the so-called zinc spangles, is a kind of surface topography of hot-dip galvanized steel sheet and coil.
The size, luster, and surface appearance of zinc spangles depend on many factors, but they are mainly related to the composition of the zinc layer and cooling methods. In order to produce zinc spangles meets the requirements, it is necessary to reduce the solidification temperature of the zinc solution.
hot-dip galvanized steel sheet

No sequins
The sequins cannot be seen on the surface of the steel sheet with the naked eye, also called a zinc-free coating, which is produced by controlling the chemical composition of the zinc liquefaction. Zinc-free steel products can be produced by adding aluminum in zinc solution, without the addition of lead, antimony, and tin. The process is widely used around the world because it allows uniform surfaces to be achieved without additional equipment. It offers superior corrosion resistance and better coating performance, suitable for various purposes of modern industry, it is the ideal base plate of color coated sheets.
Normal spangle
Normal sequins are those with a diameter of more than 3mm that can be distinguished with the naked eye, also known as large sequins or natural spangles. The best internationally recognized size is 8~12mm.
Minimized spangle
Minimized spangles is the spangle with diameter of 1~2mm. After the hot galvanized sheet came from the zinc pot, spray water mist or zinc powder for no solidification of the zinc layer, water droplets or zinc powder particles will form a crystallization center, which will increase and decrease the area of the zinc unit surface will form to the naked eye can distinguish small spangle. However, this process often causes uneven zinc unevenness and high production costs, so it is not widely used at present.
Current international standards also define zine sequins differently. They differ only in the size of the flower and the morphology of the crystals.
There are two types of EN (EN 10346 DX51D+Z):
1. Normal spangles (N): it is not necessary to control the solidification process of the zinc layer, and various sizes of zinc flower or no flower are allowed;
2. Minimized sequins (M): it is necessary to control the solidification process of the zinc layer to obtain a small zinc flower (usually invisible to the naked eye).
The classification of Japanese is close to European standards. There are two types of JIS (JIS G3302 SGCC)
1. Normal spangles (R): zinc flakes formed during the crystallization and solidification of zinc plating.
2. Small Sequins (Z): Limit the formation of normal zinc sequins to a small amount.
ASTM zinc spangles can be divided into three categories (ASTM A653):
1. Normal spangles (N): It is not necessary to control the solidification process of the zinc layer, and various sizes of zinc flakes can be generated during the natural solidification process;
2. Minimized spangles (M): It is necessary to control the solidification process of the zinc layer to obtain a relatively uniform and small-sized zinc flower still visible to the naked eye;
3. Zinc-free spangles (F): small zinc-free flowers, invisible to the naked eye, can be obtained by means of control.
The GB/T 2518 rating is similar to the ASTM standard.

